Hi folks, totally new here. Have been playing around with song writing for the last 10 years. I don't mind writing but recording and mixing (to end up with what I have in my head) is the difficult bit aint it! Steep learning curve.

DAW: Acid Pro 7

Soft Synth: Fruity Loops 11
Record Input: Microsoft Sound Mapper
MIDI Device: Oxygen 25 Keyboard (USB plugged)

In Preferences> MIDI (is set as Oxygen 25) ..same in Fruity Loops

Hello! Thank you for reading. :)

I just got an email from UA. I don't think they intended it to be shared with everyone otherwise there would have been a weblink. I just wanted to share the gist of the email. Essentially they were letting UAD-1 and UAD-1e users know that as of the next update to UAD drivers, the UAD-1 and UAD-1e cards will no longer be supported. Nice though that they are offering a generous trade in option.

Ok, so I haven't had any good luck (Or response) on my other posts and this is probably because I've been asking the wrong question.

So, a choir has just arrived from Bentonville, Arkansas, to our church. I went along tonight and the place was filled with flight cases.

I swear I could've jumped through the roof with joy, I honestly cannot believe that 12 flight cases of audio gear are sitting alongside our tiny little setup of err, a Phonic mixer and some PG58s.

i have been hear ALOT of bad things with USB Interface. If i had a choice and the budget to choose other wise i would, but i dont.

My main question is will the Alesis Multimix 8USB 8 Channel Mixer work fine with my Dell Inspiron E1505 laptop?

Since I came here looking for help in mastering a project, I thought I should let you guys know what a great job Mike Fossenkemper did for me. I’ve always wanted to work on records and with great artists, but it just didn’t happen for me. I work with very small budgets and “we need it yesterday” kind of gigs.

My midi problems are solved by way of completely restoring OMS. Something went screwy. By the way, I have had problems with Waves plugs clipping out, I have no solution but to avoid them when I have a lot of material hitting the meters hard.

i thought i'd take a minute to post a couple of quick things since i haven't had a chance to be around much the past few days.