x
anonymous 9 August 2005

Hello

So in the process of exploring the knobs in a pair of Cbs's volumax's i've proceded to screw it all up.
i'm trying to calibrate the unit again in accordance with the manual but it requires the output to be loaded with 600 ohm's.
the unit's transformer balanced on in and out's.
where do i put the load? lets say i make 600 ohm's out of resistors do i load across ground and hot?
hot to cold?
cold to ground?
i'm not sure
also can i just plug the out on to another compressor's in that is 600 ohm's.

Thank you very much

all the best
antonio

Comments

anonymous Tue, 08/09/2005 - 14:15

Wow

Thanks kev.

i have the manual so i recon i'll be ok with your info.

5khz 1.6mv adjust one of the variable resitors to out .5volts
etc....
but without the proper load i guess i could not do this.

Thank you.

ps: i began my quest of turning everything to see if i could adjust attack time of the thing but no dice. and also to open up the high end.
i somewhat did manage to open up the high end a bit but after really listening closely all i was doing was distoring giving the apperance of more high end.

i have another unit that i can compare with that i have not touched.

Again thank you this is great!

x

User login