When I use ADAT devices with PT ... both TDM and LE
I leave PT as the master and force the unit to chase PT.

If the unit can't do that reliably ... I don't use it.

:(
sorry, that probably doesn't help you much

Try lowering your hardware buffer as low as possible while tracking. If that isn't good enough, try low latency monitoring mode. If that doesn't drop the latency enough, you'll need an outboard mixer to solve the latency problem.

Kev, that does help... thanks! I'll try that next time Pro Tools "Internal" clock should be able get the OctoPro to sync off that.

Only way to reliably get 16 x 8. That's the whole reason for buying that optional ADAT card in first place to get 12 mic ins + 4 line.

Doesn't the octopre only allow word clock in thru a bnc connector which the 002R does not have? I just used a similar unit (the Presonus Digimax LT) and had absolutely no problems using external clock thru the adat input with the buffer set at 128 samples (about 3ms) and the dae buffer at its highest.

If your using OSX make sure you disable "journalling" in your system and recording drives, as these can cause activity spikes which can shut you down at the worst times and constantly eat at your PT system headroom. You can see these spikes in the system activity window in Protools and they do recede when journalling is disabled.

My System
OO2R
G5 dual 1.8 w 2 G Ram

Dave62 wrote: Doesn't the octopre only allow word clock in thru a bnc connector which the 002R does not have?

:shock:
mmmm
that could be a problem
and no the 002 does not have a BNC
this is one area the 002 should have been better than the 001 ...

oh well .. perhaps next time with the 003

Also on the 003 wish list-smux/adat input so that my rosetta 800 can input/output 8 channels of 88-96khz.