Skip to main content

Hi Neumann lathe users out there,
I bought a vms70 lathe 3 weeks ago and now being installing it.
there are some damages in the circiut breaker but I hope i find a replacement for the damaged IC .
So I only have checked all mechanical functions jet. I adjusted my truntable it has an vertical movement of 0,01 mm now. When I cut an 14 " on the outer diameter the goove is changing its width and depth. In the microscope this change is 0,5 mils so its not very much. Can it have electronical reasons ? for example the depth control ? The cut is very quiet its only a visual problem I hope.
One more question:
Do you have any suggestions for a good preview delay under 1000 € ?
Thanks for your anwers

Comments

sauger Tue, 04/25/2006 - 02:47

jase wrote: Hello,The vertical movement is the problem.Where are you based and who is servicicing your lathe?, These are problems that should be dealt with by a pro. Pm me if you need help.
Jase

I´m based in Germany, Augsburg. The service is done by a Enegneer normally used in old tape maschines. So he is now getting into the new theme of disc cutting lathes right now.
So you think its an elektronikal problem in the vertical movment of the depth coil , am I right ?
thanks for helping out !!

x

User login