Skip to main content

Very usefull:

Disable ACPI in Windows for AUDIO.

e.g.
noise with ACPI ( Pulsar card )
was by -55dB
noise without ACPI -64dB

Comments

anonymous Sun, 05/06/2001 - 17:59

How does this affect the operation of the system in Win98SE? We do this in Win2k with one CPU so that the IRQ's can be manually assigned but I would appreciate more info about doing this in Win98SE. We are using CUSL2-C systems with PIII 1GHz CPU's, 512MB RAM and RME audio cards. Matrox G-450 for graphics.

anonymous Mon, 05/07/2001 - 00:58

Deinstal ACPI in Win 98SE

1. Start/run and type regedit and press ok.
2. HKEY_LOCAL_MACHINEEnum and remove the Enum folder.
3. reboot and ignore/cancel all driver install prompts.
4. Control panel/Add New Hardware/next/next/No/Next/System Devices/
Next/highlight standard system devices in the left pane and
scroll to Plg in Play BIOS (fail safe) in the right hand pane
and ok it apply it and let the system re-detect your hardware
and point it to the correct drivers.
5. Instal IDE driver : Conrol panel/Add New Hardware/Next/Next/No/
Next/Standard harddisc controller/standardbus for IDE harddisc
controller.
6. Reboot.
7. Finally go into the Device Manager and re-enable the DMA mode
on your hard and CD-Rom ( eventuelly re-instal chip driver update ).

Go into your BIOS assign IRQ-s to your
devices (by ASUS MBO: Advanced /PCI slot/
F10.
Reboot.
Go into Device Manager/system components/
PCI-Bus/enable BIOS/disable IRQ steering.
Rebot.

regards agaton.

x

User login