Hi all, I recently purchased an Allen&Heath https://www.gearslu… Zed R16[/]="https://www.gearslu… Zed R16[/].
I have my Keyboards and drum machine connected via line inputs and when I mute any of the channels I can still hear the instruments quietly coming through.
Which is making me feel I have a lemon.
All channels are being routed to L+R main mix and all routing buttons are in the up position.
Aux sends are turned fully counter clockwise.
I've always noticed on any desk that mute means mute right..total silence?
I hope someone can see something I am missing and save me sending it back.
Thanks for your time.
Ell
Comments
Boswell, post: 434727, member: 29034 wrote: This must be either
Boswell, post: 434727, member: 29034 wrote: This must be either a fault on your board or else an inadvertent switch setting. It doesn't behave like that on my Zed-R16, so I don't think it's a design problem.
Is it the same level of breakthrough on all mono channels? What about a stereo channel?
With just the KB or drum machine playing through a muted mono channel line input (not one of the stereo inputs), does it make any difference if you press the yellow DIG RET button for that channel? What about if you press the PFL button? What do you hear when you release the channel's L-R button?
So if I for example chl 4+5 receiving drum machine and both are muted with no gain and their faders all the way down, L+R buttons depressed and both DIG RET pressed, I can hear the drums faintly. If I depress DIG RET then it's even louder. If PFL buttons are pressed I hear them loud and clear as expected and if DIG RET are pressed with PFL pressed then it's faint. L+R main faders are at 0db during this.
With the channels muted and their faders at 0db and L+R buttons depressed I again hear the drums faintly..even when faders are all the way down.
This must be either a fault on your board or else an inadvertent
This must be either a fault on your board or else an inadvertent switch setting. It doesn't behave like that on my Zed-R16, so I don't think it's a design problem.
Is it the same level of breakthrough on all mono channels? What about a stereo channel?
With just the KB or drum machine playing through a muted mono channel line input (not one of the stereo inputs), does it make any difference if you press the yellow DIG RET button for that channel? What about if you press the PFL button? What do you hear when you release the channel's L-R button?