ceiling

So I've seen a lot of studio spaces and researched a lot. Basically I'm remodelling an 35' x 25' unfinished room (looks like an unfinished basement but above ground) and building 3 rehearsal rooms.

Hi all,

Ceiling Cloud - An acoustical panel suspended in a horizontal position from ceiling or roof structure.

Ceiling Attenuation Class (CAC) - Rates a ceiling's efficiency as a barrier to airborne sound transmission between adjacent closed offices. Shown as a minimum value, previously expressed as CSTC (Ceiling Sound Transmission Class). A single-figure rating derived from the normalized ceiling attenuation values.

I am having a back garden practice/recording cabin built. Structure will be (from outside to inside)

Concrete base with DPM
timber frame (total area 4x5m)
OSB with 18 mm shiplap cladding
4x2in wooden studs
100mm RW3
2 layers of 15mm acoustic plasterboard.

Roof
OSB covered with EPDM

I'm building a live room for my studio. The room is a former bedroom and the dimensions are not ideal. (8'2" H x 12'1" x 12'9 1/2", plus a small alcove that was a closet with bifold doors. Doors have been permanently removed.) I do have the ability to completely rip it apart and rebuild it, but due to budget constraints, that will have to wait. For now, I'm working with what it is.

I was looking at these ceiling clouds by Primacoustics...they measure 24 inches x 48 inches x 2 inches

Perfect for the area I want to cover above my mix position

Has anyone out there had any experience with or used / currently using this one?

What attracts met to this particular one is not only the size, but its lightweight construction and ease to fit.

Hi, here are a couple of pictures of my recent ceiling treatment project. My recording/rehearsal studio was too dead, and I decided to install some reflectors/diffusers to liven it up a bit.
A full writeup, including some sound samples, is at www.cloneensemble.com/diffusers.htm.

Can a bank of ceiling fans being turned on or off mid-way through a venue cause a change in the way a room responds to or reflects/absorbs sound waves, thereby causing feedback problems?

I moved my entire studio into a bedroom that has really low wood ceilings (7-8 feet). My vocals and acoustic guitars seem to have a lot of bass. I'm using a RODE ntk. Do you think I should move it to an area where there is vaulted ceilings? The room its in now is probably the quite room in the house. Would using an eq fix the problem?