Where has my Digi001 sound gone?

anonymous 23 February 2002

I recently re-installed my Digi001 system on my G4 and this time cannot get any sound out of the track playbacks. Everything is functioning properly on screen and everything was installed according to the Digi001 Quick Start Guide. I've tested the headphones I'm using to make sure they were not the problem. Ideas, anyone?

Log in or register to post comments

Comments

Create a master fader? See if any signal is present on the mixer

Guest Sat, 02/23/2002 - 18:01

Create a master fader? See if any signal is present on the mixers meters?

perhaps take off any plug ins on the master fader?

???

Log in or register to post comments

Check your I/O page to see if all is routed correctly. Also c

Kev Sat, 02/23/2002 - 19:44

Check your I/O page to see if all is routed correctly.

Also check the channel strips for your output routing. They are going to the stereo bus.

Check that monitor switch on thefront of the 001. I fall for that once in a while.

Log in or register to post comments

Ask your question at the Digidesign user conference 'DUC' in the

damster Tue, 02/26/2002 - 07:00

Ask your question at the Digidesign user conference 'DUC' in the digi001/mac section.I'm sure sure you will be well serviced there. :tu:

Log in or register to post comments