Everyone loves the RNC. But everyone dreads using it in its stock unbalanced state when running long cable runs. So that will be my next DIY project: balancing my RNC.
What will it take? I know, a few nice transformers and a new case, possibly a new power supply, but has anyone done this before. I don't believe I have the electrical skills to pull this thing off uncoached, so any help would be awesome.
Comments
Originally posted by try2break: So that will be my next DIY pr
Originally posted by try2break:
So that will be my next DIY project: balancing my RNC.
What will it take?
Two Jensen transformers would do it. Talk to Jensen to see which transformers would do the job. http://www.jensentransformers.com
Mark Plancke
Originally posted by mats.olsson@rockfile.se: 2? Isn´t 4 requier
Originally posted by mats.olsson@rockfile.se:
2? Isn´t 4 requiered for balanced stereo in+out?
/Mats
Yep, my bad.
Mark Plancke
mats, How many transformers needed will be dictated by what sig
mats,
How many transformers needed will be dictated by what signal you send to the RNC and what signal you need to have coming out. Depends on your output from the board. Can you send an unbalanced signal from an aux or insert or secondary main out? Are ya gonna use it as a sub bus compressor, main bus compressor or insert? Just some thoughts...
Lundahl makes some high quality converters with built-in transfo
Lundahl makes some high quality converters with built-in transformers. See http://www.lundahl.se/catframe.html
under category 'problem solvers'.
marty
Depending on your application, you may only need to balance the
Depending on your application, you may only need to balance the inputs in order to get common mode rejection.
The input transformer will allow common mode rejection and avoid unbalancing the output of sensitive balanced gear.
An unbalanced output feeding the appropriate level into and expecting the correct impedance from a balanced input should sound fine. And the inoput transformer down the line will still do common mode rejection even if the signal isn't differentially balanced.
In this way, perhaps you only need 2 transformers?
Kyle
What kind of scenario would require long cable runs for an RNC?
What kind of scenario would require long cable runs for an RNC? Why wouldn't you keep it pretty close to the mixer?