I want to make my guitar sound better andlokking for new ways of or Mic-positions.I use SM57(Down) and MD 421 (Up) just normal positions
Tags
Comments
for recording heavy guitars..i've pretty much thrown out the 57.
for recording heavy guitars..i've pretty much thrown out the 57...i've used it with some success..but love a condenser..2 feet in front of a 12"..(414, u87, etc)
Agreed. A 414 at the above mentioned position also works well for a Pop solo when mixed with a little 421 on the grille.
I have thrown the 57s away in favor for MD421s. If you do the A/B with similar patching, you will find the 421 to have more guts and punch than a 57.
Another mic that you might try is an AKG D12, right in the middle against the grille. Mix a little bit of it in with the 421; it adds some growl to your axe.
If you have access, patch into a Neve pre-amp/EQ on your way to tape. You'll smile as you listen! :)
Hi guys You should try a Beyer M88 or M69 (which has less low
Hi guys
You should try a Beyer M88 or M69 (which has less low end) instead of the 57 or 421.
I never liked the 57 for recording (heavy) guitar and the 421 is quite hot sounding, but when recording a band in one room the spill is too much.
A Beyer will give you the sound you have in the room when listening to the speaker cabinet and the spill is almost zero.
Have fun! :tu:
what kinda amp is it? 1 speaker...2? 4x12? couple tricks i've
what kinda amp is it? 1 speaker...2? 4x12?
couple tricks i've picked up....
1 mic 2" away 1" from center..straight at it..and a 2nd mic..same place but 30-45 degrees offset...the phasing if done properly can actually work for you...might sit nice in the mix..
trick 2..get the first mic sounding decent, then
pump white or pink noise through the amp...and move the 2nd mic till u get the least amount of sound (or lowest meter level)...and then flip the phase..
for recording heavy guitars..i've pretty much thrown out the 57...i've used it with some success..but love a condenser..2 feet in front of a 12"..(414, u87, etc)
cheers