Skip to main content

I'm sure there are other topics on this but wanted to get some direct help. Our church went from an analog board to a digital one (Allen &Heath iLive T112). We actually just had some reps come in and put all new equipment in... But I have tried compression and eq'ing but I can get a low punchy kick drum. On our old analog board, I could get a good kick drum by turning the low cut filter off (along with compression and eq'ing) What am I missing on the digital board? maybe lowering the frequencies of the high pass filter would help? I know the system can handle it because I have played some kick drum .wav files and it sounds really good. any suggestions?

Comments

Voiceofallanger Fri, 03/04/2011 - 18:33

You should get some low end yes, despite churches being very reverby sound dispersing environments.. BUT...........

If not lambchop's suggestion then it might be worth checking A) Do you have any outboard stuff hooked up? If so try bypassing it until you narrow things down... and B) Are there any pass filters on the desk? Maybe a sneaky high pass is flicked on somewhere...

Who knows, just throwing suggestions really...

dvdhawk Fri, 03/04/2011 - 22:00

jcbv, post: 365547 wrote: maybe lowering the frequencies of the high pass filter would help?

If it's on, switch the HPF off on the kick drum channel, or lower it all the way down to 20Hz (virtually the same as turning it off). If that doesn't help they may have put in something to roll of the low-end in the main section of the iLive or at the crossover / amps end of things.

Keep digging, it sounds like you're on the right track.