x
frob 5 April 2005

i was just wandering if it is worth it to DIY pads and if so what to use for that aplication?

part two: what pads do you use if you dont have one on the pre? also does it make that mutch of a difrance.?

Topic Tags

Comments

Kev Wed, 04/06/2005 - 00:09

If the Mic-pre is already assembled and all you have is an XL3 input then am in-line pad built into an XL to XL adapter is a cool idea.

You will need different units for Mic use and Line level use.

Many pages on the net with resistor values for different situations.

For some Mic-pres it can make a great deal of difference.

frob Wed, 04/06/2005 - 10:29

kev your exactly the person i wanted to respond to this. what in interested in is inline XLR pad for mic level.

i was also interested if any one out there new of posable store bought brands what they used and sutch but i dont know if any one that uses them is goin to even look at this thred with my subject line. ooops

Kev Wed, 04/06/2005 - 13:55

err
was that typed in a hurry ?

Mic pads do require a different resistor balance.
That's not to say that a line level unit won't work cos it will.
It's just that it may not give the PAD amaount as marked.
It may also change the load on the Mic such that it sounds different ... could be worse ... could be better. ... just different

Shure !!
had an in-line pad with dip switches.
do a net search

I'm sure we can fine some pages with tables for both Mic and Line level PADs
I start looking.
The DIY factory needs a page like this anyway and I should get on to that.

I'll be back

here's is one to get started with
http://www.uneeda-audio.com/pads/

RANE
cos it's a good page
http://www.rane.com/note110.html

x

User login