Modifying Blue 8Ball LDC?
I have a blue 8 Ball LDC mic that cost me nothing and that I’m not very keen on.
- Read more about Modifying Blue 8Ball LDC?
- 2 comments
- Log in or register to post comments
finding a new belt for Yamaha mt2x 4 track
hi there,
I came across one of these in a music store for $15.. but it was diagnosed that it needs a new belt. I know this might not be all that's wrong with it but if that IS all that's wrong with it, I'd be willing to buy that and open it up, but my question is does anyone know where I might find a belt for it?
- Read more about finding a new belt for Yamaha mt2x 4 track
- 6 comments
- Log in or register to post comments
Digital piano headphone output signal is low and noisy when connected as line
Hi all,
Looking for some help here...
AMEK Angela - LED meter problem
Hi,
The LED meters on my AmekAngela have this problem that it takes about a minute for the LEDs to shout down after the music stops,you can see it in this video:
- Read more about AMEK Angela - LED meter problem
- 37 comments
- Log in or register to post comments
Troubleshooting new setup
Hey guys, instead of calling it bad luck, I'm calling it an opportunity to learn.
I scooped one of those "beginner all in one" guitar / amp kits a couple days ago, where the whole thing is in a box, with picks etc etc. It's a first act brand and was $85 total.
- Read more about Troubleshooting new setup
- 17 comments
- Log in or register to post comments
A&H GS3000 mpu problem
I have a GS 3000 console turn of the century stuff. The Mute mpu board has gone out part 002-347-1 so all the mutes seem stuck off and mute and status leds are stuck on. No LCD. Everything else works.
Need to find a replacement or figure out how to fix it. The pcb makes use of a P80C32 40 pin chip and what appears to be a 5v power supply.
Any ideas?
- Read more about A&H GS3000 mpu problem
- 47 comments
- Log in or register to post comments
Studer A807 eprom dead
Does any one have Bin likes for Studer A807 mk 1, current version installed was 40/87, but can change to later version if available.
D
- Read more about Studer A807 eprom dead
- 5 comments
- Log in or register to post comments
Help! Soundcraft cps275
My cps275 +/- 17V light is not on, is it causing stop give the power to my console? I can see the lights on and off a sec when I shut down the cps275 on my console. Checked the fuse, doesn't seems like blew. Does anyone know what is happening?
- Read more about Help! Soundcraft cps275
- 13 comments
- Log in or register to post comments
Repairing a Shure 545?
Greetings-
I recently bought an older Shure 545 (4-pin Amphenol era) on eBay, and while it works, it sounds a bit of the dog with voice: a greatly diminished low end, and reminiscent of talking through a paper towel tube.
- Read more about Repairing a Shure 545?
- 16 comments
- Log in or register to post comments
Does This Switch Wiring Work For What I Want?
I want to break a signal path which has no discrete components in it as of now. I want a 3 position toggle switch to have the options of Stock (signal pass through), Resistor 1 (signal path broken and routed into Resistor 1), and Resistor 2 (signal path broken and routed into Resistor 2). I've been pondering this, but I think I have figured out how to do it.