As different vocalist needs different headphone volume/reverb while tracking,
are these parameter can be changed by the vocalist in tracking room by putting some gears(like headphone amp, mixer...) in it?
Or these should be controlled by the engineer in control room?

If by the vocalist,
what equipment should I need to do this purpose?

I am trying to use our Tascam US-1641 with all channels in our church for multi-track recording. I have a Rolls RA62Ah headphone preamp mixer that I am thinking of trying to use to where I can adjust the gain coming into the 1/4" inputs on the back of the US-1641. Can I use this as long as I use stereo cables? And would this be possible to use without damage to the unit?

Hey everybody, I was wondering what would be a good start for a 4 channel headphone amp for me to use while laying out a Guitars / Drum track both individually but in the same performance and what would be some affordable headphones to use along with it?

Thanks,
Jonathan Soliman

Yeah, I know this has been discussed before, but it hasn't helped me make up my mind. This has been at the bottom of my list. I have a Behringer unit that I paid about $30 for. Of course, it has more features than anything under $1000 but sounds bad. Still. it's not in the signal chain so I put off upgrading.

So I need a headphone amp to run 4 sets of 'phones this weekend. I ordered a B******r AMP800 online, mainly for the low price and the fact that their headphone amps seem to be the only products they offer that don't get regularly shredded here on RO.

My ADA interface is an E-MU 0404 PCI card:

http://www.sweetwater.com/store/detail/0404/

With its outputs leading to my PreSonus HP4 headphone amp:

http://www.sweetwater.com/store/detail/HP4

Which then go to my studio monitor and headphone mixes.

ok so for some reason i cannot hear live or playback signal coming into the headphones BUT i when i push the talkback button on my O2R i can hear talkbalk just fine. any idea's of what may be causing this?
thanks

Can anyone recommend a reasonable priced good headphone amp I need a minimum of 4 channels. I'd like to stay around $100.00 if possible.

I have a couple of techie questions which I was hoping someone familiar with equipment would be able to answer. First of all, my set-up.

M-Audio Firewire Solo connected to Rolls Ha-43 Headphone amplifier, connected to a Tascam VL-X5 (monitor speakers).

Okay, here are the questions:

Specific problem

What's up?

I just picked up a Lectrosonics PA-8 8-Ch Power Amp for peanuts on eBay. It is a 6w x8 @ 8Ohm, or 10w x8 @ 4Ohms power amp of very high quality. http://www.lectrosonics.com/lecnet/pa8.htm (Retail over $1300)