He'll everybody just joined and have a MOTU issue.
Using Reaper,Win 7 homebuilt I7, 8 gigs ramm, MOTU 2408 with updated 424 card, using analog inputs for guitars and bass and PreSonus d8 for real drums. Everything was fine until...today.
This morning started guitar track had to go out, came back and had no sound at speaker point.

Have a chance to grab one for real cheap including the PCI-424 card. But is it for me ?
For recording I use a lot of keyboards, my bass, and occasional elect guitar tracking.
Along with a small amount of outboard reverb / delay units.
Cubase 5 PC based system.

I've been slow coming to the age of digital recording, so please assume minimum knowledge on my part, despite that I've copiously read all my manuals and watched YouTube videos 'til my brain is mush.

I have a MOTU 2408 Mark 1 and 2-ADAT blackface and 2-ADAT XT-20s. I am trying to get the Adats into my computer but I can't seem to find a way to get Cubase or Reaper to see the optical inputs. I also don't have a manual for the 2408 and have not had any success locating one via google, yahoo, etc. Can anyone help me to get my ADAT tracks into my computer digitally?

Hi everyone,

Hi folks, here's a question regarding sync,

My actual setup:

PC with Gigabyte EP45-UD3R, WinXp Pro Sp2 (installed older version because I argued driver probs)
MotU PCI324 card and 2x 2408MKI connected.
Actual drivers installed, device detected, no probs.

HELP! I just hooked up 3 ADATs with their optical outs into the A,B,&C banks of the 2408. I am using Samplitude and tried recording the 24 tracks but all i get is noise. The recorded audio looks as though they are the digital waveform pulses. Is this a direct transfer from the ADATs? They definitely look like the square wave equivilents.

Hi Guys, I'm using 3 x MoTU 2408 with Cubase vst5 on a mac g4. I'm having a problem trtansferring a track from my Fostex DAT via the optical connection through my TC finalizer then through sp/dif into the motus and then into Cubase as a stereo master file, which I can cut and export to burn. I'm getting digital glitches on the transfer.

--

I was just wondering if this would be a good choice and if i would be able to use it with my Yamaha MG16/4 mixer / how i would go about hooking it into the mixer so that each mixer input goes out to seperate inputs on the MOTU.