One month back, I'm recording. Life's a dream. Now despite no change (that I can think of) in my recording process, a white noise or otherwise a static crunch plagues my every new recording.

I apologize in advance if this turns out not to be the right forum for this question. I'm essentially a noob when it comes to recording. You may see in my profile but I put together a fairly simple setup with an Audio-Technica AT-2020 connected to the art MP studio V3 preamp with its phantom power supplying the condenser mic.

I have an MXL 770 Mic that runs over a Roland XLR cable to a Roland Rubix 22 Audio Interface. Pretty much everything in my loop is brand new and Im getting this horrid background noise all the sudden.
No matter which mic I use I still get the same static.
Whether I have a mic plugged in or phantom power on or off I get the same static result.

I have a Sennheiser transmitter-receiver ew100 G3.

It's going into a Canon XA20 pro camcorder, into the Input on the Handle, which is set to Mic/Manual/flat (center). It's always worked fine for me until lately.

Hey guys,

I'm new here so apologies if I could have posted this in a better section :)

I'm using the MXL 770 along with the Behringer U-Phoria UM2. Now, the Behringer use to make a lot of noise until i updated a driver. I knew it was the audio interface since i disconnected the actual recorder from it, and the laptop still allowed me to record. Now after that problem is gone, i still find background noise when connecting to the condenser mic.

Hey all, this will be my first post on the forum.
I seem to have a problem with static/white noise. even when my mic is muted on my Behringer x2222. My mic is an AKG P420.
The white noise always shows up when I normalize a track, whether I'm recording nothing or my guitar or voice. I'll put up some pictures of my configuration too. Thanks for the help in advance!

Hey Guys,

Hi

I made a account here because I can't find help anywhere else.

I have had microphone problems for about a year.
When I touch computer case the noise isn't so bad but still exits, and when I move microphone in some positions the noise changes little bit. Time to time it was so bad that mic didn't pick my voice at all. Sometimes it was like helicopter...

I've been using an AT4040 for years and then all of a sudden yesterday it started giving me this really weird and loud static. I tried swapping out the cable, but still the same result. I tried another condensor and that one worked fine through the same cable, pre and interface.