Can anyone help me? Twice now I have had tracks cut to acetate for vinyl production and the engineer said there were problems with the phase on my tracks. One of these tracks was a solo sound from a Roland JV1080 synth.

Hi guys. I am having problems with a mastering suite. My master is on DAT and when they master to vinyl the sound is all distorted, mainly the vocals. They inform me that this is my fault because I have used certain processing on the vocals that do not work with vinyl. All I have used on the vocals are a Focusrite Voicemaster Pro with compressor, harmonics and tube sound all built in.

Hi,

Can anyone throw me some album titles that have been remastered and released on vinyl?

i currently use a Shure M44-7 with a Technics 1200 turntable + NAD phono pre.
during mixing, i find myself dipping the EQ of the vinyl samples at various points between 1 and 5 k. mainly around 3k.

is there a cartridge more suitable for getting samples to be used in mixes? usually drums (kick/snr/cymbals/toms/etc.)?

i was told the Shure M35S would be better choice.

Hi There,
Looking for some help on deciding what software & media would enable me to come out with the best recordings possible.

My set-up is: 2 Turnatbles going to a mixer, out of mixer to a M-Audio USB sound card, then USB to my laptop. This set-up is so i can record my mixes then burn onto CD.

hello!

right about know i am about to finish a lp master that's supposed
to be released on vinyl...

thats what i did so far:

analog eq-ing and some compression

result:

eq and dynamic wise all the tracks sound homogenous now !

everything good so far.

now i have all the tracks down on my daw
all levels close to 0db...

Can anyone help me ... I am looking for a way to only make one vinyl record so I can play concerts from that vinyl .. any suggestions on where I can make only one record for not too much money .. any help is appreciated .. Thanks ..

Zeff

p.s. I live in New York..

I know there has been interest on this forum as to the quality of cut from Vinylcarvers in London. They have developed a cutting system of their own design (no small feat) and have sent me a reference disc to check out.

Hi Guys ..
thanks for all your help with the last little Mastering to Vinyl session . All the tips have been a big help . especially Tom's to check mixes with a low pass and high pass filter to see if the definition stays ..

Hi ...
My name is jeremy and i make electronic music . Always on vinyl . i've got about 6 records out now so everything is finally moving from being an experiment with the finished product to now knowing more or less which way to point the ship.

i had a few questions : i'm sure good mastering is good mastering but vinyl can be tricky and requires special care .