Skip to main content

Session starting in a couple hours. But my monitor mixer 1604VLZpro has developed a nasty problem. It's as though there may be a cold solder or dirty connection somewhere across the mix L/R bus. The right channel goes away completely and left is very low in level. But a loud plosive sound though a mic will bring both channels back to full level. But before long (minutes) the levels disappear again. Other than "get a decent mixer" can anyone suggest where my problem may lie after experiencing similar problems. If I get through today's session, I may be borrowing Fletchers stick! But for now if it's a simple fix, I may have time to tear into it. Anybody seen this in a 1604 and have any idea what to look for? I've never had one opened up.

Thanks
Bill
http://www.GigaBoyAV.com

Comments

Kev Sat, 01/26/2002 - 11:26

Dry solder joint or a suspect connection.

Check all connections and then lift the lid and check connections in the mixer. Not many in a Mackie. Look for solder joints that are dull, they should be shiny and wet looking.

I hope there is not a crack in a PCB track. Hard to find and could be delecate to fix.

good luck.