Im unsure of these cables i made for connecting balanced outputs of my mixer(TRS) to my crown power amp in(XLR).

I wired them this way:
pin1=TRS ground
pin2=TRS tip
pin3=TRS sleeve

Hi all,

I've been looking at the Pod series of audio interfaces. For example the Pod 2.0. I'm wanting a guitar amp simulation device and quality effects.

I have an orignal Fender Blues Deville 1993. I really need to replace all tubes, i dont really understand what my options to choose from are? can someone help?

I have not looked at power amps for 5-6 years. All of the usual suspects: crown, qsc, Yamaha have "new" models since I last look. I am currently looking for a power amp for my live bass rig: POD - Power Amp - Cabinet. I'm trying to go light weight. I'd like the power amp to be good for PA if I decided to rearrange things.

I own a pair of KRK ST6's ...
100w 8 ohms

I have a guitar amplifier which I do not use, and I want to convert it into a bass combo amplifier. What if I want to switch out the guitar speaker with a bass speaker? Where would I buy one? Are there any considerations for this type of speaker transfer? If so, where can I purchase a 12 inch bass speaker? Are there any speakers which are better than others?

If you take a DI on your bass track and then proceed to amp that bass track and mix it in with the DI, what if the two tracks are out of phase, but you like the mic positioning on the amped track. I remember hearing about a plugin where you can adjust phase by the degree for a total of 360°, but let's say you don't have this and need an alternate method. What would you do?

For the past 6 years ive mixed used just a stereo systems speakers :( Though with DECENT results ...

I ust bought a par of KRK ST6's... I really need to buy an amp. Unfortunatly, i want to stay below $300..
I know there cheap speakers...Is it worth spending a ton on a amp?

Here are the specs:

Hi,
I just purchased a pair of PMC TB1 monitors and am looking for advise on what amp to buy to power these speakers, my budget can stretch to about €300 and preferably 2nd hand. The speakers will be used as main monitors along with Auratone Single Speaker & Samson Servo-170 amp in my control room.

Thanks in advance for any suggestions

Man, I thought I had a handle on this but apparently not.

Using Samplitude, Sonar, Cubase, Logic, Reaper whatever... (shouldn't matter what DAW correct)? what do I need to get 16 channels of I/O to a Dangerious 2-Bus or my SPL MixDream and back into my DAW? ( not concerned with cable) just the converter options for now.