I want to use a single stereo bus output to connect to multi track recorder and I want the stereo bus connected to all of the 8 channels in pairs so 4 stereo pairs

If I take the single bus O/P and daisy chain (or connect in parrallel) to the recorders 8 channels would this be OK or do you have to have a channel per input.

Okay, something has to be wrong with my STC-8. It has no headroom which leaves me to believe the jumpers are wrong inside the box. The guy I bought it from said he did the jumpers for the softer KI knee and more input headroom for mastering but this thing is clipping way before it should. Its a year old and looks mint but yikes, it cannot be this lame. Could be why he didn't like it.

Say you have a piece of electronic equipment which has an input impedance of 1Megohms, and an input capacitance of 10 picofarads as determined by a ceramic capacitor across the input resistor. This obviously creates an RC impedance filter which will act on any AC entering the device.

Hi,

I use a FF800 as the "brain" of my system.
I use two Digimax LTs as the ADAT 1 and 2 into the FF,
Unfortunately, these units only have inserts, and no true analog outputs.

I currently have:
9 actual outputs (8 analog and 9/10), and the way TotalMix is setup, they are mixed as stereo pairs, leaving 5 discrete outputs (minus some clever panning, when possible).

Hi, I'm new to this forum and recording in general, but I was hoping someone here could help me. I just bought some infrared wireless headphones thinking that they would allow me to use the metronome in Ableton Live without having it appear in my recording, but to my dismay it's audible - even if I record and the microphone wasn't on.

Hello,

I'm trying to use Logic with Digidesign TDM hardware system and I can't seem to output an audio track to a single output channel. I only get an option of 'output 1&2' or 'output 3&4'. I can't just select a mono audio track to output to 'output 1'. I normally use an Apogee Symphony system in core audio mode and this isn't an issue. Is this a limitation of a TDM setup?

Ok so. I have a 12 Channel mixer(soundcraft efx) and i record with it into reaper v3.1415

I works really nice..but the RCA rec output sends the master mix into reaper.. is their a way to send the channels seperately into reaper? i want to gate and eq and play around with each drum indevidualy withought changing the whole drum mix..is this possible?

Hi,