Skip to main content

I have a small setup: Logic, Firebox, Eureka with digital card. I have been around the horn several times as to what my options are for a better digital connection b'tween the pre and the FB and now I am wondering if there is any reason for it. How reliable is the wordclock over the S/PDIF port? Will I see any sonic improvement by adding a wordclock option (which is also much more expensive)?

Additionally, I cannot slave the Eureka S/PDIF to my Mac. Right now (at least with 10.3.8) it won't sync to an external clock source w/o an independent wordclock. With 10.3.9 I can't control the clock source and so I can't set my FB to slave to the Eureka. Ideas?

Comments

Opus2000 Sat, 04/30/2005 - 10:27

It really depends on the device outputting the clock to be honest. By far word clock would be the best choice as it's a dedicate clock and not a header in an audio path. That's how you get clock from digital audio sources, there's a bit status basically that is sent out which tells the receiving device the information it needs. With word clock it's only clock information.

The device itself, depending on the buffering and overall design, may make your audio worse. Remember this, some converters will happily degrade your audio!

In the end always try to use word clock. If all you have is SPDIF, you work with it till you can use word clock.

Your Mac problem....no idea m8.

Opus

ghellquist Sat, 04/30/2005 - 12:28

I will try to paint a little different figure here. It is very much about generalizations, and we all that in the specific case it might be very different.

1 - if you have no need for synchronizing several devices, if at all possible use the internal clock. This goes mostly for AD of course. The internal AD clock in almost all devices is several times better than what you get with an external clock. (Contrary to what some marketing people try to make you believe).

2 - if you transmit a signal to a DA for playback, it is not much use in having a separate word clock. SPDIF or ADAT is good enough for that. Especially in my mind (not quite tested in real world by me though) if you run on an optical cable.

3 - if you do word-clock, do it right. Use the T connectors and terminators (read the manual).

Gunnar.

pcrecord Sun, 08/19/2018 - 06:30

Even if this is a 2005 thread, the question is still valid today.
Digital audio needs to be synchronized in order to be aligned properly to each other and in your software and avoid glitches and jitters.
Most recent audio interfaces today have relatively good internal clock. If you want to connect 2 units together, one of the 2 needs to be Master and the other slave.
The timing can be passed via wordclock, via spdif or ADAT connections. There ain't any winners here they all do the same job.
But if you want to introduce a 3rd unit, spdif and Adat are not made to be chained. So you need to use wordclock.

In any case (for those who found this via google search) the 2 or more units need to be setup identicaly for exemple all to 24bit96khz. If one isn't set like the others it won't sync.