What do... I .. do?

*Note: I did know the proper board for this.

Note: This could be drenched with fluff and extra length, as I am quite a expatiator when it comes to the realm of explanation~ aka, I always say more than needed in every category, especially when it comes to asking questions.

Wondering if any other small town studios have encountered this as it's turning into an epidemic where I live

Man, I thought I had a handle on this but apparently not.

Using Samplitude, Sonar, Cubase, Logic, Reaper whatever... (shouldn't matter what DAW correct)? what do I need to get 16 channels of I/O to a Dangerious 2-Bus or my SPL MixDream and back into my DAW? ( not concerned with cable) just the converter options for now.

I debated on whether to put this in the Pro Audio or Pro Recording Forum... pretend it's in both.

Hi, been out of the music game for around 10 years and i am slowly unpacking my gear in order to start recording again. I have recently acquired a TC finaliser Plus and i am confused to which cables i required to connected this into my setup.

I am thinking of hooking this up as follows; Mackie - control room out - finalizer in - finalizer out - studio amp - monitors.

What are your favorite Genelec studio monitors?

http://www.vaultwik… Wiki - VaultWiki - Wiki for vBulletin Forums[/]="http://www.vaultwik… Wiki - VaultWiki - Wiki for vBulletin Forums[/]

what do you think of this for recording.org?

ok i bought a delta 1010 lt 8 mono ins and outs ive got a dynamic mic plugged into mic 1 of the delta and speakers plugged into 1/2 out of the delta.i want to pan my vocals to left or right on recordings but if i hard left i hear nothing hard right i can hear playback but the volume just lowers down i have no mixer or pre-amp just speakers,headphones,dynamic mic,magix music studio software,what

Hi,

Cucco, or anyone for that matter:

I'd love to hear how you setup your Dangerous 2-Bus with FireFace 800?
routing,cables,outboard gear etc?
I believe you mentioned you have Sequoia as well?

What do you use for a monitor control system?