I am building a recording studio that will have 8 headphone circuits. I need to install the cable. The input of the cables will be 1/4" stereo plugs and the outputs will be 1/4" jacks built into electrical boxes with cover plates. I can't use a snake due to the geography of the studio. What kind of cable should I use. Size, type, etc?

Hey I was wondering if I could get as much feed back as I can from you guys about the monitors. I have read great things about both of them, but was wondering if anybody has an opinion on either or?

First of all i'd like to say hello this is the first time on the site just found it like a hour ago wish i woulda found earlier.

I was wondering the Neve porticos eq will make good eq for mastering. I just bought a Portico setup, including 2 eq and a tape driver and u can bus them all together. Im only miising the compressor. I was also wondering if the Portico compressor will do the trick or it will be better to get a multiband compressor? Thanku

Hello!

I'm one of the few who still hapen to be using sound designer for some part of my job, and i was kind of wondering if you guys would know any woftware who would have such a great scrub, and do powerfull destructive editing?
(running on mac or PC)

In our project studio, we have several pieces of gear that use 9 volt AC wall-wart type power supplies. (When you have 16+ wall-warts, I think the term "infestation" is applicable).

ill be buying a firestudio project soon, and i was planning on getting a dual eq and dual compressor for the inserts on ch 1 and 2 on the firestudio. i was thinking of a preamp aswell just to give some different sounds from the preamps in the firestudio, so i looked up some Joemeek stuff. they have a dual compressor and dual eq all in one, i think it could be a preamp too.

ok so i just got a dell laptop recently and would like a temporary way of recording. mostly just acoustic solo stuff, guitar and vocals (if i could do more, great). what is the cheapest way i can get some decent recordings just using my laptop and some software? and whats the best way to go about mics this way (i have one 1/8" mic input and a sm57+mxl 990)

any advice is great

to start off, i used to have a decent little set up, but i moved from ohio to florida and i needed money at the time so i sold my Behringer mx9000 and Mackie sdr 2496, along with a Shure pg series drum mic kit.

anyways, i plan on getting back into recording sometime later this year once the finances clear. heres what I'm thinking about going with

I just picked up a "new" TLM 103 for $500. Less than a year old and never been used. Thank you craigslist!