I have this mixer but the power connector has come off on the back and no idea where the wires solder back to the power connector so if anyone knows how to solder the connector and what colour goes to each pin i can then repair the mixer 

Hi, I have an Alesis MultiMix 4 mixer and a single QSC CP8 speaker. The manual for the mixer says to use 1/4 TRS for the main outs. And the speaker has a female XLR input. So my question is, if I only have one speaker, should I get a dual 1/4" TRS cable that terminates at the other end as a male XLR? Is that the proper connection when I only have one speaker?

Currently working on replacing the flyback switching power supply in the Alesis DEQ830, with a linear supply.

Hi everyone,

I'm reasonably new to recording and have never used Rack Effects before. I have been given an Alesis Micorverb 4. Now this is the stupid question bit -

Looking to get some help regarding my setup. I currently have an HD24XR, the digital outs are connected to the digital ins of the RME and so are the Ins. Total Mix controls the RME. I want to be able to record onto the hd24. When its full. transfer the tracks to reaper and mix.
Issues I have.

Hello everyone. This is actually my first post, but I was wondering if someone could help or point me in the right direction.

There's this occasional https://soundcloud… tick sound  that occurs on playback perhaps every 15 seconds to 1 minute. I tried swapping cables. Tried playing into a different system. This sound is coming from the ADAT XT.

Hello All,

I just found this forum.

I am a professional studio musician (drummer). I want to use my Alesis HR-16 as a click track and have the tempo driven from Pro Tools.

I've done this many times in the past but I don't know exactly how the engineer went about setting it up.

Hello guys!

I was just given the Alesis Multimix 8 USB but my friend had accidentally thrown out the power supply with some other old electronics. As it would turn out, this is very hard to find. There are no after-market power supplies made, as far as I can tell. The specs are 18V 500 mA and here is a picture of what I need: