Here’s one I’ve been working on. any feedback or ideas
 

Attached files me too remaster.mp3 (8.5 MB) 

it gets real good about 20 minutes in.
 

Are there phase issues when tracking acoustic direct in and mic at same time?

This part of a series of music I had restored from tape written and recorded a few years back. So you could say it's Hybrid recording. This came from a project that was never really finished and with all the time down since March 2020, I had time to finally restore the 16 tracks and drop them into Pro Tools sessions for enhancement and sweetening.

https://distrokid.com/hyperfollow/bendavis3/a-thin-place

Howdy folks. Link Here is my COVID project

six originals and two covers
Really appreciate the feedback from the pros on this site. Made it possible and gave me confidence to stick with it

Been a while since I posted a tune. Been at it hard taking knowlege and input from past postings. I finished a record of originals. Should be on spotify and such soon

been working on some new songs

heres a depressing countryish breakup tune for you wolves to tear apart!

any input welcome

My big struggle is learning to use reverbs better.

I noticed that many mixers such as the Behringer hard wire their line inputs (without even a switch) in parallel with the mic input to the mic preamps. Yes, they do have a drop resistor but that's all. My concern is that the signal is being dropped and then amplified back up - thus adding another stage and more noise.

Hello everybody,

I am fairly new to the world of studio audio recording, so need a bit of advice, in my setup I have full HD rig, and have added a Behringerada8000 to the setup for preamp mic's etc for drums and mis, set ada to slave, connected light-pipe cables etc, get audio into ada but not out to any pt session's, checked hardware and io settings and seem to be ok, or am I missing something as getting frus

Working in this little song idea... any thoughts or suggestions