Hi!

I'm relatively new to recording and would be grateful if someone could help me with getting my gear setup to record.

I run a rehearsal studio with 3 rooms and will be using my office as a "control room" to record either rehearsals(basic recording) and/or multitrack recording of bands for demo's etc.

My gear consists of the following:

So I have been interested in getting a tape deck for a while now. The deal on the AG-440s fell through, and I was very depressed for a few weeks... :lol:

http://www.Alesis.com/multimix8usb20

I'm looking at investing in one of these. Does anyone have one or know much about them?

The reason I need it is so that I can record drums properly, with multiple mics, with each track assigned to a track on Cubase.

Hi, can someone throw some names out for me, i'm looking for a preamp and a converter for my pc setup, here is my initial problem:

Hello RO,
I have a couple of cheap shock mounts I got for a couple of MK-319's off ebay about ten years ago. Also, a third one for a AKG C4000B/414.

The black colored cord thats used to keep the shock mount strung has lost its elasticity. Does anybody know where to get more elastic cord and metal hardware to connect the ends?

I'm trying to connect a Shure SM57 microphone to computer. I have Shure SM57 XL2 to TS connected to Behringer Mic800, and TS (unbalanced) to 1/4" line-in connected to a splitter to both L &R the line-in on the Audiophile 192.

I can't seem to receive a signal using the setup.

So, a choir has just arrived from Bentonville, Arkansas, to our church. I went along tonight and the place was filled with flight cases.

I swear I could've jumped through the roof with joy, I honestly cannot believe that 12 flight cases of audio gear are sitting alongside our tiny little setup of err, a Phonic mixer and some PG58s.

I am by no means a home recording guru - as a matter of fact, I know almost nothng. I recently got a brand new Tascam digital portastudio DP-02, and I can't seem to get it to playback after recording a track. I've looked in the manual and can't find anything relating to this problem - it should be able to playback right after laying down a track. Any suggestions?

HELP! I just hooked up 3 ADATs with their optical outs into the A,B,&C banks of the 2408. I am using Samplitude and tried recording the 24 tracks but all i get is noise. The recorded audio looks as though they are the digital waveform pulses. Is this a direct transfer from the ADATs? They definitely look like the square wave equivilents.

Having some problems with my mix downs… talked to a few people and I am starting to think it’s the sample rate conversion.