Skip to main content

Hey,

Is there anything in the $600- range worth looking at as far as small diaphragm condensers go apart from the Oktava MC-012 from The Sound Room and SP C4s? I was thinking used 451s, but I've heard they're quite too bright at times. I was also thinking about SM81s.

Instruments that will be recorded:

Upright piano in stereo.
Acoustic guitar in stereo and mono.
Cello

Not as often as the above:
Drums (might get separate mics)
Pump organ
Celesta

Mics will probably go through FMR RNP, Neve 1272 Clone or Peavey VMP-2.

Thanks,

EIK

Comments

AudioGaff Sun, 09/14/2003 - 09:36

If you don't need true stereo then I'd pick one 451 and one SM81 from the choices you have and sources you listed. This gives you some variety and flexability. Buy another one of both or either latter. Piano or acc. guitar do not need two of the same brand mic for stereo.

451's can be bright but they are tamed well with good mic placement and something slower and mellower like a 1272. I would much rather use eq to cut any overly brightnees then to have to boost high end eq after. SM81's are hit and miss to me because they are so flat. Sometimes that is good and sometimes it's not.

anonymous Sun, 09/14/2003 - 16:38

Cool, is the general consensus to go with the older or newer 451?

Piano or acc. guitar do not need two of the same brand mic for stereo.

Would you say any of the instruments I listed do? Just so you know, there will be 2 mics for one instrument at a time. There will be no ensemble recordings with the pair.

AudioGaff Sun, 09/14/2003 - 19:05

Would you say any of the instruments I listed do?

Drum OH is about the only thing I think needs the same mics for stereo other than ORTF and NOS techniques which are not usually used for rock/pop/hop.

Older 451's are a little more mellowed or aged and I prefer them, but unless you know the history and could demo and could get a very good price for a used 451, you might as well buy a new one or a new reissue used one. I bought my 452's used years ago from a mastering engineer I worked with a lot so I got lucky. Having pairs of real great mics is always a good thing. But if you have a small mic collection to choose from now, it can be better to have more variety and flexability in mics that to have a few of the same.

I wouldn't likely get a 451 and SM81 together as they are more towards the same than they are different. I would get one and get something much different that would compliment the other and fill the gap the other was missing. Again this is what gives you much greater flexability and variety.

anonymous Wed, 09/17/2003 - 14:54

I would scrape together another $300 and get a matched pair of the Josephson C42's

Here's a quote from Scott Dorsey taken from a RAP posting. I hope he doesn't mind. The last sentence grabbed my attention.

From: Scott Dorsey (kludge@*****.com)
Subject: Re: Josephson C42 Mics for acoustic guitar
Newsgroups: rec.music.makers.guitar.acoustic, rec.audio.pro
Date: 2003-03-10 08:11:17 PST

Scott Von wrote:
>Anyone have any experience with these mics recording steel string
>acoustic guitar? The cost for a pair is very reasonable when viewing
>the competition...

Try them and see. I think you will find they are about as clean and accurate
as it gets unless you go up to the Schoeps/DPA price range. On the other
hand, for steel string I can see your wanting something a bit more mellow
on the top end rather than accurate."
--scott

I've heard lots of good stuff about the Neumann KM-84s. They can be found for decent prices on eBay. The problem there would be that I probably couldn't return them if I was unhappy with them. Also I believe there's a problem with "transformer taps" on some of those mics. At least I could return the C42s depending on the dealer.

The guitar I will be recording the most is a Gibson J-45, 95% picking all over the neck, probably mostly in mono.

[ September 18, 2003, 08:36 AM: Message edited by: EIK ]

MPlancke Fri, 09/19/2003 - 07:03

Originally posted by EIK:

I've heard lots of good stuff about the Neumann KM-84s. Also I believe there's a problem with "transformer taps" on some of those mics.

Nonsense. The only transformer issue on any older Neumann microphone; in fact many vintage microphones including AKG's is that the transformer can be set to 200 ohms or 50 ohms.

Gotham, the importer of Neumann microphones way back when required that all microphones coming into the North America market have the internal transformer strapped for 50 ohms and the internal pad engaged. IIRC this reduced the output by approximately 6db. This was so the microphones would not overload the equipment being used at the time. Since this is no longer an issue it is a fairly easy matter to change these things. It is not a defect.

Any competent tech can check and/or change the transformer tap and remove the pad in a few minutes.

Mark

[ September 20, 2003, 08:55 AM: Message edited by: MPlancke ]

Davedog Fri, 09/19/2003 - 08:44

All of the mics mentioned have their own wonderful uses. You cannot go wrong with any of them. Dont overlook the Audio Technicas in your search...the 4051 is a very nice mic with a nice boost starting @around 2K...the 4041 is a bit flatter but is avaiable in only cardioid whereas the 4051 has changable capsules.Another mic which is just coming into its own is the ADK SC-T.This one has a very warm sound as compared to some of the 'accurate' mics in this class.Not to say its not accurate but simply a bit warmer.Still, you cant really go wrong with an SM81.Or a KM84.etc.

sdevino Fri, 09/19/2003 - 16:40

You can also get a pair of Earthworks SROs small omni's for $600. I have a pair of KM184's that do not get used much. I can see using them in a really thick mix because they are really exceptionally bright and even brittle IMHO. The KM84 is much warmer so don't be confused.

I think the sound of the KM184 is so bright that I would not want it as my only or even primary choice for a SD mic. Many other mics mentioned above would probably get more all around use.

Steve

anonymous Wed, 09/24/2003 - 02:57

Originally posted by yon:
Everybody I've heard of who's used both the c42 and the newer km184 say that the c42s are smoother in the top end, more like the older km84s are.

Another consideration for cheap SD condensers are the Crown CM700.

Or the matched pair of Studio Projects C4 mics. They come with a pair of omni and cardioid capsules and sound great so far (I just got them an hour ago ;)

Mats