http://www.supersonicsamples.com

I'm looking for a program similar to Drumagog or SoundReplacer for VST or DX (for use in Sonar 6). I got FXpansion's BFD not understanding that it isn't what i'm looking for. (unless it is, and then i'm an idiot) Thanks

I have had this ART Pro Channel in my studio for years now and I would like to breath some new life into it. I ordered and installed Ei 12AX7 Elites and TungSol 12AX7 [ NEW PRODUCTION] tubes only to find that both had issues. The Ei's had +17 dB noisefloor over baseline factory tube. The TungSol tube has a bad harmonic distortion at about 300hz.

Okay - so my beloved K2 is apparently having a problem with the factory tube. For the first 30 minutes of a session, it sounds fine. After that, the mic starts to get very thin and muffled to the point where it eventually stops receiving/sending signal at all.

So, I'm looking for a replacement but I'm not good at which tube can replace what with minimal problem.

Hi guys

I want to replace the valves in a Behringer 1952 that I have. I will use one channel to compress bass and the other for guitar.

Any sugestions on what tubes I should be looking at?

Thanks
Kuzan

Hi,

Hello. This is my first post on this board but i have been reading it a lot for a while and it has been very helpful to me.

Hi, the backup battery in my Sony R7 has low voltage and I need to replace it. I don't have the manual though so does anyone of you know how to replace it without losing the presets ? And what type of battery is it ? Anyone know where to find the manual online ? Help appreciated as always.

I recently bought an old Allen & Heath System 8 1616, sixteen track mixer for decently cheap because it didn't have a power supply. After asking around online I figured it would be about $100 to $200 to either buy a replacement or have one built, the schematics are available.

I'm still using a DDP as my main compressor/limiter. I've had this thing for about 5 years now and have not had any problems. And I know there's others that'll make it look as if you're using this thing like a Alesis 3630. What I'm wondering is, will I need to upgrade to a better compressor or have an additional compressor added? My other's are software based.